2014 Honda CRV Engine Block Heater Installation Manual — Information for users Honda CRV 2014 we have provided in a PDF format file about repair manual. This guidance is how to install the Engine Block Heater in 2014 Honda CRV. to perform the installation you have to have your equipment also supplied complete with a bit of automotive science. before doing the installation you should read the following guide. please continue your reading installation ways manually on your vehicle.
Disconnect the unfavorable cable from the battery.
Enable the engine and all cooling system parts to chill down.
Place a clean drain pan under the radiator drain plug, then remove the drain plug from the bottom of the radiator to drain the coolant. Remove the radiator cap to increase the flow.
Be certain to empty the coolant utterly, change the radiator cap to prevent contamination from coming into the radiator.
Take away the 2 self-tapping screws and the three clips from the left entrance wheel arch protector.
Take away the left front wheel arch protector (eight clips and three retaining tabs).
Repeat steps 5 and 6 to take away the correct front wheel arch protector. On all sides of the automobile, attach masking tape to the entrance bumper, left headlights and left front fender.
Attach masking tape to the front grille and entrance bumper. Take away the four clips from the entrance grille.
Using a flat-tip screwdriver, launch the 4 clips from the underside of the front grille. Using a long blade flat-tip screwdriver, launch the one clip and the two retaining tabs from all sides of the front grille. to complete the guide, please see here.
That’s all that can udugs be said about the way install engine block heater 2014 Honda CRV. I hope the above can help guide your work. good luck.