How to Install Aero Screen in 2002 Honda S2000

Honda S2000 Repair Manual — Here we would like to share information about the installation of accessories in the Honda S2000. accessories that will we put here is Aero Screen. well if you want to try to do the installation then please continue reading the instructions below. all equipment that will be required you can see at the end of this post.

Aero Screen Installation

Using a pushpin, mark the console lid at each of the two dimples situated on the inside.

While carrying eye protection, drill a 5 mm gap by means of every mark: a. First drill with a three mm drill bit, then end with a 5
mm drill bit. b. The console lid is a hollow building with the higher and decrease plates surrounded by a series of bosses. Drill the holes squarely till the tip of the drill bit comes by the upper plate. c. To prevent the console lid plates from distorting from extreme warmth while drilling, drill the holes slowly.

Using a round file, take away any burrs from the edges of the holes. Be careful not to harm the bosses.

Place the aero display on the console lid, and set up the two screws. Make certain the aero display screen is spaced equally on each sides. If vital, file the screw holes until the aero display is centered between the roll bar trim on each side.

Set up a washer and a cap nut on the top of each screw, and tighten the cap nuts securely. Place a cap over the top of each screw.

Be certain the aero display is not interfering with the roll bar trim when the roof is in the stored position. If essential, file the mounting screw holes, and test the clearance again.

How to Care and Use

The aero display screen plastic lens has a particular protective coating. To prevent the coating from cracking, keep away from utilizing glass cleaners, leather-based cleaners, or sharpening supplies to scrub the lens.

Clear the aero screen solely with a soft cloth or a sponge dampened with a solution of mild dish washing soap and clean luke-heat water. Permit the aero display screen to dry out of direct sunlight.

Tools required for installation

Drill, 3 mm and 5 mm Drill bits, Eye protection (face shield, safety goggles, etc.) Round file, Phillips screwdriver, Ratchet, 8 mm Socket, and Pushpin.

Thanks you for visiting this blog. we hope you are successful with this.

Summary
Review Date
Author Rating
51star How to Install Aero Screen in 2002 Honda S20001star How to Install Aero Screen in 2002 Honda S20001star How to Install Aero Screen in 2002 Honda S20001star How to Install Aero Screen in 2002 Honda S20001star How to Install Aero Screen in 2002 Honda S2000