Nissan Juke 1.6 Dig-T Hardpipe Kit Installation Manual

Nissan Juke Installation — Free pdf file about repair manual on the type of Nissan vehicles. there are some guidelines on how to install Hardpipe Kit on the Nissan Juke 1.6 Dig-T which we will present in this article. before you do the work you should read and take a complete file of the guide below.

Summary Instructions

Raise the vehicle on a ramp or suitable axle stands, to allow access to the underside of the front of the car. Open the bonnet.

Using a small flat blade screwdriver or similar tool remove the 4 off plastic clips running along the top of grill.

Moving to the underside of the vehicle, remove the plastic clips in the center of the bumper.

Using a Pozi Screwdriver remove both covers from in front of both wheels.

Using a flat blade screwdriver remove the plastic clip located at the front in both wheel arches.

Carefully pull the arch extension away from the bodywork.

Pulling the arch extension to one side, use a 10mm spanner and undo the 1 off M6 bolt on both sides.

Carefully pull the bumper away from the clips that run up the bodywork and under the headlight. These are the last fixings holding the bumper to the vehicle.

For this part you may require a second person. One person to hold the bumper while the second reaches inside to undo the connectors to the fog lights. Place the bumper in a safe place to prevent damage while working on the rest of the vehicle.

Remove the foam crash bar cover and store away from the vehicle.

Good luck and I hope you are successful after following the above instructions.

Summary
Review Date
Author Rating
51star Nissan Juke 1.6 Dig T Hardpipe Kit Installation Manual1star Nissan Juke 1.6 Dig T Hardpipe Kit Installation Manual1star Nissan Juke 1.6 Dig T Hardpipe Kit Installation Manual1star Nissan Juke 1.6 Dig T Hardpipe Kit Installation Manual1star Nissan Juke 1.6 Dig T Hardpipe Kit Installation Manual

Popular Search :

juke hard pipe (1)
You might also likeclose