Audi TT RS Installation — Here is a pdf file form instructions on how to perform a manual repair Audi vehicle types. This is the manual on how to install Front Mounted Intercooler on the Audi TT RS. before you do the work please take the complete file here.
Park vehicle securely, jack the front of the car and support on axle stands so that the front wheels are clear of the ground ,raise the bonnet. Now remove the two plastic trims which cover the lights by pulling the trim in the direction indicated by arrow “A” from under the slam panel. Then pull off cover in the direction of the arrow “B” to completly remove the trim.
Now the covers have been removed you will be able to see the back of the light. Unplug the connecter from behind the headlight on the passenger side, by pushing down where indicated and pulling the plug backwards in the direction of wiring. Repeat for the drivers side headlight.
Undo the three T30 screws retaining the headlights,these can be seen by looking directly down on the headlights ,The one to the left and the one to the right only need to be loosend where as the one in the middle will need to be taken out.
Now the lights have been removed you will be able to see where the wing and bumper are bolted together. Remove the two 10mm nuts which hold the bumper to the wing, and repeat this on the drivers side.
Remove the two lower T25 screws connecting the bumper to the arch liner. You will need to turn the wheels on full lock to gain access. Repeat on both sides.
Tools Needed for Audi TT RS Front Mounted Intercooler Installation : T20 screwdriver/bit, T25 screwdriver/bit, T30 screwdriver/bit, 10mm deep reach socket and suitable ratchet, Sharp Stanley knife or Dremel, Brake pipe/hose clamp, Jack and axle stands. that’s all we can say in this post. I hope this article can help you trouble. thank you